Effect of double-application of three single-step self-etch adhesives on dentin bonding and mechanical properties of resin-dentin area.
Oper Dent. 2009 Nov-Dec;34(6):716-24
Authors: Wei S, Shimada Y, Sadr A, Tagami J
Abstract
PURPOSE: This study investigated whether double-application influences the bond strength of single-step self-etch adhesives and the mechanical properties of the resin-dentin area.
MATERIALS AND METHODS: Three single-step self-etch adhesives (EXL-683, experimental, 3M ESPE; Clearfil Tri-S Bond, Kuraray Medical; G BOND, GC) were applied on dentin surfaces by using the single-application or double-application method. The manufacturers’ instructions stated use of the single-application method. Resin composite (Clearfil AP-X, shade A3, Kuraray Medical) was then placed and light cured for 40 seconds. The microshear bond test was carried out and the bond strength data were analyzed using one-way ANOVA with post hoc. The hardness (H) of the bonding layer, resin-dentin interface and dentin beneath the interface at depths of 10 microm and 100 microm were measured with a nanoindentation device (ENT-1100, Elionix). The H data were analyzed using two-way ANOVA, one-way ANOVA and the independent t-test at a significance level of alpha = 0.05.
RESULTS: The mean bond strength with single-applications of EXL-683, Clearfil Tri-S Bond and G BOND were 39.1, 36.9 and 30.0 MPa, respectively, while with the double-application, they were 46.9, 40.2 and 32.2 MPa. Double-application for EXL-683 to dentin showed significantly higher bond strength than single-application alpha < 0.05. However, there was no significant difference between the single- and double-application methods for the other two adhesives alpha > 0.05. The H of the bonding layer was significantly influenced by both the adhesive material and application method alpha < 0.001; the H of the bonding layer with a double-application was significantly improved compared to a single-application. The H of the resin-dentin interface was significantly affected by the application method alpha < 0.001, but not by the adhesive material (alpha > 0.05). Neither the H value of dentin at 10 microm nor a depth of 100 microm was affected by the adhesive material or application method (alpha > 0.05).
CONCLUSIONS: The double application of EXL-683 did improve the bond strength to dentin. The hardness of the bonding layer and resin-dentin interface was significantly affected by the double application for each material used.
[cite source='pubmed']19953782[/cite] – indexed for MEDLINE]