«

»

May 14 2019

Print this Post

Ultra-high-speed videography of resin-dentin interface failure dynamics under tensile load.

Icon for Elsevier Science .

Ultra-high-speed videography of resin-dentin interface failure dynamics under tensile load.

Dent Mater. 2019 May 08;:

Authors: Hosaka K, Tichy A, Ikeda M, Nakagawa K, Sadr A, Tagami J, Takahashi M, Sato K, Nishitani Y, Klein-Junior CA, Pashley DH, Nakajima M

Abstract
OBJECTIVES: Ultra-high-speed (UHS) videography was used to visualize the fracture phenomena at the resin-dentin interface during micro-tensile bond strength (μTBS) test. We also investigated whether UHS videography is applicable for failure-mode analysis.
METHODS: Ten human mid-coronal dentin surfaces were bonded using Clearfil SE Bond either in self-etching (SE) or etch-and-rinse (ER) mode. After 24-h water storage, the samples were cut into beams for μTBS test and tested at a cross-head speed of 1 mm/min. The fracture phenomena at the bonded interface were captured using a complementary metal-oxide-semiconductor digital UHS camera at 299,166 frames per second. The failure modes were classified using UHS videography, followed by scanning electron microscopy (SEM) analysis. The failure-mode distributions determined by UHS videography and SEM analysis were statistically analyzed using Fisher’s exact test with Bonferroni correction.
RESULTS: The crack-propagation speed exceeded 1,500 km/h. No significant difference was found between the SEM and UHS videography failure-mode distributions in the SE mode. A significant difference appeared between them in the ER mode. Significant differences in the incidence of cohesive failures within the adhesive and at the adhesive-composite interface between the SE and ER modes were identified by both SEM and UHS videography.
SIGNIFICANCE: UHS videography enabled visualization of the fracture dynamics at the resin- dentin interfaces under tensile load. However, the resolution at such high frame rate was insufficient to classify the failure mode as precisely as that of SEM. Nevertheless, UHS videography can provide more detailed information about the fracture origin and propagation.

[cite source='pubmed']31078308[/cite] – as supplied by publisher]